Job Title

Are you looking to work for a company that provides an innovative work environment, and your voice is heard?We are looking for a Global Interior Lighting Product Design Engineer to work in Windsor Ontario.The Global Interior Lighting Product Design Engineer will be responsible for the design, development, and release of all the Interior lighting components such as smart ambient lighting, surface back lighting, dynamic lighting, overhead lighting system, Battery charge Indicator lighting, UVC lighting, courtesy, and task lighting. Responsibilities will include but not limited to:Standardization plan development, interface with product design office, vehicle development, other Interior, Mechatronics, Electrical Engineering Teams, and suppliers to design, develop and release Interior Lighting componentsInterface between Design Studio and suppliers in the creation of functional lighting solutions that achieve design requirementsMaintain core lighting design practices, lessons learned, implementing innovation roadmaps as well as utilizing SPEOS lighting simulation as a lighting simulation tool, coordination, and development of advancement of new technologies and procedures to improve program timing for lighting systems, writing source packages, specifications, requirements, and change noticesDefine Interior, Electrical, Customer interface requirements, virtual and physical validations (DFMEA / DVP&R), vehicle lighting harmonization and quality improvement activities, cost value analysis, and the supplier development and selection process, supplier management to meet program timing and deliverablesFollow, track and root cause build issues found during pre-production builds and vehicle issues found during developmentIssue resolution prior to launch of the program and warranty analysis of all the components after the launchRequirements: Needs to be in the Windsor area for Occasional meetings at CTC and training. State on the resume where the candidate is located. A minimum of a Bachelor of Science degree in Electrical, Mechanical, Mechatronics, and or Computer Engineering from an ABET accredited universityMinimum of 2 years of Product Design and Release in Automotive system and componentsMinimum of 2 years in Electrical Module Hard ware developmentExperience with Tooling feasibility in Injection molded plastics/Decorative componentsExperience in Interior lighting and lighting simulationWorking knowledge of Design Failure Mode & Effects Analysis (DFMEA), PFMEA, Design Verification Plan & Report (DVP&R), CAE, GD&T, and i-SpeedDesign and development experience in Team Center and NXProficient in Excel, Word, Power PointStrong organizational, leadership and communication skills requiredResult oriented, energetic self-starting leader with ability to direct cross -functional teams Additional Information / Must Have's:Excellent communication and skills in person and virtually. Problem solving experience, Reactive green belt certification preferredAssembly / Production plant experienceHow many years of experience are you looking for (if different than the job description): 5-7 years